background image

12 

 

 
 
 
 
 
Exclusion of implied warranties – Your sole and exclusive remedy is product repair as 
provided in this Limited Warranty. Any implied warranties, including the implied 
warranties of merchantability or fitness for a particular purpose, are limited to two years 
or the shortest period allowed by law.

 

 

 

This warranty is extended to the original purchaser and any succeeding owner for the products 
purchased for use within the USA.

 

Some states do not allow the exclusion or limitation of incidental or consequential damages. This 
warranty gives you specific legal rights, and you may also have the other rights which vary from 
state to state. To know what your legal rights are, consult your local or state consumer affairs 
office or your state’s Attorney General. 
  

DISCLAIMER:

 The use of Field Commander/Crop Link/Aqua Trac/CommanderVP/Icon Link 

shall not be utilized by customer as a substitute for the Customer's personal observation of the 
manner in which Customer's irrigation equipment is functioning.  AgSense specifically advises 
Customer that this product is designed to enhance Customer's ability to control existing irrigation 
equipment and to provide the Customer with additional information about existing irrigation 
equipment.  Field Commander/Crop Link/Aqua Trac relies upon GPS, Satellite and Internet 
technology which not always functions properly, accordingly, AgSense disclaims any and all 
responsibility for the reliability of this technology.  Customer acknowledges that AgSense does 
not have the ability to control the reliability of GPS, Satellite and Internet Technology.  AgSense 
specifically disclaims any and all liability for Customer's failure to personally determine whether 
or not the irrigation equipment that belongs to Customer is functioning properly.  AgSense, its 
agents, members or officers will not be liable for Customer's loss of profits, business 
interruption, or any other type of consequential damages arising because of the failure to 
Customer's equipment, GPS, Satellite or Internet to function properly. 
  

CUSTOMER'S RESPONSIBILITIES:

 Customer agrees to keep the irrigation equipment upon 

which Field Commander/Crop Link/Aqua Trac/CommanderVP/Icon Link is installed in good 
repair and maintenance.  Customer acknowledges the importance of and agrees to keep all safety 
devices which came with Customer's irrigation equipment in working order.  Customer agrees to 
keep an end field stop and barricades in place to prevent damage to the irrigation equipment in 
the event that Field Commander/Crop Link/Aqua Trac/CommanderVP malfunctions.  Customer 
agrees that Field Commander/Crop Link/Aqua Trac/CommanderVP cannot solely replace the 
personal monitoring of the operation of irrigation equipment. 
  

REMEDY:

 Customer acknowledges that Field Commander/Crop Link/Aqua Trac/Icon 

Link/CommanderVP’s sole obligation and Customer's exclusive remedy in the event of any 
material and continuing nonconformity, defect, or error in the information service shall be to take 
reasonable corrective actions upon discovery of the problem. 
 

 

 

Summary of Contents for ICON LINK













Reviews: