PROBLEMS, CAUSES AND SOLUTIONS
PROBLEM
CAUSES
SOLUTIONS
The electrical
tool fails to
start
Power supply
line discon-
nected
C h e c k t h e
electric po-
wer supply
line
Plug not in-
serted
I n s e r t t h e
plug in the
electric po-
wer supply
socket and
p r e s s t h e
start button
E l e c t r i c a l
fault
Contact an
a u t h o r i s e d
service cen-
tre.
The sander
s t a r t s b u t
d o e s n o t
sand the ma-
terial or not
very well
Worn abrasi-
ve support
Replace the
abrasive sup-
port
U n s u i t a b l e
abrasive sup-
port
Change the
t y p e a n d
grain of the
abrasive sup-
port
IMPORTANT! If the electrical tool still fails
to operate correctly after you have carried
out the above operations, or in the event of
anomalies other than those described above,
take it to an authorised service centre with
proof of purchase and ask for original spare
parts. Always provide the information shown
on the technical data label.
STORAGE
Clean the machine and all its accessories thoroughly
(see Maintenance section). Protect the unpainted
parts with protective oil (excluding the driving rollers)
and use the original packaging or case (when fitted)
to protect it.
Keep the machine out of reach of children, in a stable
and safe position. The place must be dry, free from
dust, temperate and protected from direct sunlight.
Keep children and unauthorised personnel out of the
storage room.
DISPOSAL
PIn order to protect the environment, proceed
according to the local laws in force. Contact
the relevant authorities for further information
on this.
When the machine is not longer useable or
repairable, deliver the machine and packaging
to a recycling centre.
Electric and electronic waste may contain
potentially hazardous substances for the envi-
ronment and human health. It should therefore
not be disposed of with domestic waste, but
by means of differentiated collection at specific
centres or returned to the vendor in the event of
purchasing new equipment of the same type.
The illegal disposal of such equipment may
result in prosecution to the full extent of the law.
WARRANTY
The product is protected by law against non-
compliance with the declared characteristics
provided it is used only in the manner described
in the instructions, it has not been tampered with
in any way, it has been stored properly, has been
repaired by authorized and, where applicable,
have been used only original spare parts.
In the case of industrial or professional use or
when using such a guarantee is valid for 12
months.
To issue a claim under warranty you must
present proof of purchase to your dealer or
authorized service center.
