- 15 -
crank and its bearings / pins), so as to cover
them with a thin layer; insist mainly in the
areas of bearings / pivots to make it penetrate.
Attention! It is not necessary to fill the chamber
of fat as it would cause a malfunction of the
power (leakage of grease, failure of percussion
etc.). If the fat is attached to the walls of the
room, pick it up and deposit it with the brush
on the mechanical and only if the fat is dirty
access cover and replace it with the new one.
5 Clean the area of the hole and screw the cap
on tightly.
6 Wipe any traces of grease on the tool.
WARNING!
- Never put your fingers inside the hole.
- Do not insert the brush fat too deep.
- Never put grease with a spatula or your
fingers.
- Do not exceed the amount of fat, an excessive
amount causes the malfunction of the tool.
- Never start the tool if the cap is not screwed
on properly!
STORAGE
Clean the tool and all its accessories thoroughly
(see Maintenance section). Protect the unpainted
parts with protective oil and use the original
packaging or case (where fitted) to protect it.
Keep the tool out of reach of children, in a stable
and safe position. The place must be dry, free from
dust, temperate and protected from direct sunlight.
Keep children and unauthorised personnel out
of the storage room.
DISPOSAL
In order to protect the environment, proceed
according to the local laws in force. Contact the
relevant authorities for more information.
When the machine is no longer usable or repai-
rable, deliver the machine and packaging to a
recycling centre.
Electric and electronic waste may contain poten-
tially hazardous substances for the environment
and human health. It should therefore not be
disposed of with domestic waste, but by means
of differentiated collection at specific centres or
returned to the vendor in the event of purchasing
new equipment of the same type. The illegal
disposal of waste will result in administrative
sanctions.
WARRANTY
The product is protected by law against non-
compliance with the declared characteristics
provided it is used only in the manner described
in the instructions, it has not been tampered with
in any way, it has been stored properly, has been
repaired by authorized and, where applicable,
have been used only original spare parts.
In the case of industrial or professional use or
when using such a guarantee is valid for 12
months.
To issue a claim under warranty you must
present proof of purchase to your dealer or
authorized service center.
