- 9 -
g
!
!
WARNING! Connection to the power supply
network must be made with a 230V~50Hz
socket with an earthed contact. See attached
technical data.
MACHINE DESCRIPTION (FIG.A)
1 Pump body
2 Coupling handle
3 Pump base with liquid suction
4 Delivery
5 Starting float
6 Power supply cable
7 Technical data label
8 Adjustable base
SYMBOLS (FIG.B)
1 Technical data
2 Double electric insulation
3 CE conformity mark
FIELD OF USE OF THE PUMP
Pump to clear and turbid water
The submersible pump is suitable exclusively
for sucking up water where it is possible to
immerse it directly. It can be used in sumps,
tanks, containers etc. where there is no direct
contact between people and the water (it is not
to be used in swimming pools and similar, unless
otherwise stated). Using the float switch, the
pump is started and switched off automatically
according to the water level.
The pump is equipped with an adjustable base
that allows to extract clear water from a mini-
mum of 1mm up to 8mm high, turbid water from
a minimum of 35mm.
CONNECTION TO THE ELECTRIC POWER
SUPPLY
The pump is equipped with a connection cable
and plug. Connect the plug to a appropriate
socket which must be equipped with an efficient
earthed contact.
Check that the socket is efficient and that it has a
protection device for over currents of at least 6 A.
WARNING! Always check that the cable
and the plug are not damaged. Do not use the
pump if the cable is damaged!
!
!
If the power cable is damaged, it must be
replaced by the manufacturer, support service
or qualified staff in order to avoid any dangers.
!
!
WARNING! Installation Standards
- Always observe the values of ‘maximum immer-
sion depth’ and ‘maximum head’ shown in the
specifications.
- Do not transport aggressive liquids or liquids with
abrasive substances in a suspension.
- Protect the pump from freezing.
- Do not operate the pump dry.
- Never hang up the pump by its water delivery
hose, by the power supply cable or by the float.
- The pump must be resting on its base or
hanging up using the special handle, always
upright.
- In order to guarantee optimal operation of the
pump, the bottom of the sump must be clean
and free from mud. The mud could block the
impeller when it dries inside, stopping the
pump from working.
- Do not use the power cord for lifting and tran-
sporting the pump.
- The plug should not be submerged.
- Remove the power from the pump and di-
sconnect any possible plug from the mains
before any maintenance, cleaning or moving
operation.
- Use protective gloves for each operation on
the pump.
INSTALLATION
- Screw the connection onto the pump delivery
(pos. 4).
- Fix the delivery hose onto the rubber holder.
- Immerse the pump in the liquid to draw using
a rope tied to the handle.
- The power cord must be immersed for sud-
denly only necessary but not too tense. Attach
the cable to the pipe with plastic cable ties at
intervals of 3 meters.
- Connect the power supply cable to the socket.
The float switch allows the pump to be started
and stopped automatically according to the
water level. In order to work it must be able to
move freely inside the sump. The recommended
minimum measurements for the sump are 40 x
