©
2005
Directed Electronics, Inc.
6
H1/11 BLACK (-) Chassis Ground Connection
Connect this wire to a clean, paint-free sheet metal location (driver kick panel) using a factory bolt
that DOES NOT have any vehicle component grounds attached to it. A screw should only be used
when in conjunction with a two-sided lock washer. Under dash brackets and door sheet metal are
not acceptable ground points. It is recommended that all security components be grounded at the
same location.
H1/12 BROWN (-) Horn Honk Output
This wire supplies a (-) 200 mA output that can be used to honk the vehicle horn. It outputs a single
pulse when locking the doors with the remote, and two pulses when unlocking with the remote. This
wire will also output pulses for 30 seconds when the Panic Mode is activated. If the vehicle has a (+)
horn circuit, an optional relay can be used to interface with the system, as shown below.
H1/13 LT. GREEN/BLACK Factory Alarm Disarm
This wire supplies a
H1/14 WHITE/BLUE (-) Channel 3 Output
This wire provides a (-) 200 mA output whenever the transmitter code controlling Channel 3 is
received. This output will continue as long as that transmission is received. Use for options such as
Directed’s 551T Valet
®
Start system, 529T or 530T power window controllers, etc.
IMPORTANT!
Never use this wire to drive anything but a relay or a low-current input!
The transistorized output can only provide 200 mA of current, and connecting directly
to a solenoid, motor, or other high-current device will cause it to fail.
