©
2005
Directed Electronics, Inc.
12
setting is 0.8 second door lock pulses. For some vehicles a 0.4 second pulse duration is required, this
durations is required for some vehicles to prevent the windows from moving.
5 DOUBLE PULSE UNLOCK OFF/ON: Some vehicles require two pulses on a single wire to
unlock the doors. When the double pulse unlock feature is turned on, the BLUE/BLACK H1/8
wire will supply two negative pulses instead of a single pulse.
6 DOUBLE PULSE LOCK OFF/ON. Selectable 2 pulse door lock output to operate vehicle
equipped with factory “deadbolt”. Will have similar operation to that of the Double Pulse Unlock
feature, but will perform the functions on the Lock wire as opposed to the Unlock wire.
7 COMFORT CLOSURE FEATURE OFF/ON: This feature is designed to integrate with vehicles
that can close the power windows and sunroof by holding the key in the driver door lock position,
and will operate on both single input systems and two pulses input dead bolt systems.
If programmed ON the door lock output will activate the Comfort Close output for 20 seconds.
This output will begin 200mS after the final door lock output has completed regardless of the door
lock programming.
If while the 20 second timer is active and closing the windows the user disarms the unit, the
Comfort Close output will immediately cease before the doors unlock.
8 CODE-HOPPING ON/OFF: The system features Code-Hopping as an option.
Transmitter/Receiver Learn Routine
The system comes with two transmitters that have been taught to the receiver. The receiver can store
up to four different transmitter codes in memory. Use the following learn routine to add trans-
mitters to the system or to change button assignments if desired.
1.
K
Keeyy.. Turn the key to the ON position.
2.
C
Chhoooossee.. Within 10 seconds, press and release the Valet/program switch
the number of times corresponding to the desired channel listed below.
Once you have selected the channel, press the switch once more and
HOLD it. The LED will flash and the horn will honk ( if connected) to
confirm the selected channel. Do not release the Valet/program switch.
