29
Perform an opening in the exterior wall according to the size of the wall termination. From
outside, place the outside air inlet cap in the hole (open side down) and fasten the register to
the wall, with screws as shown. Place the insulated pipe over the register tube and over the
fireplace outside air connector (see Figure 25). At each end, carefully pull back the insulation
and plastic cover, exposing the flexible pipe. Attach the flexible pipe using clamping rings.
For a better seal, you may also use aluminum tape. Wrap the tape around the joint between
the flexible pipe and the air inlets. Carefully push the insulation and plastic cover back over
the pipe. Secure the plastic in place using aluminum tape.
3.8 Faceplate
Installation (Sold Separately)
3.8.1 Narrow Overlap
WARNING: THE FACING SHOULD NEVER COME IN CONTACT WITH
MASONRY PRODUCTS SUCH AS MORTAR, ACID OR ANY OTHER
PRODUCTS CONTAINING ABRASIVES. DAMAGES AND
DISCOLOURATION CAUSED BY THESE PRODUCTS WILL VOID
THE WARRANTY.
Figure 26
Narrow Overlap
1.
Once the fireplace is fully installed, push the faceplate (C) against the non combustible
material, which must be installed on the front of the fireplace.
2.
Secure the faceplate (C) to the fireplace with 4 screws (B) supplied with the fireplace.
Always make sure the faceplate is squared to the fireplace.
3.
Make sure that the doors still slide perfectly.
Summary of Contents for FP-7-LM ANTOINETTE
