5-9
Valco Cincinnati, Inc.
MS013 - DD-1 Pump Manual (built after 9/06)
Section 5 - Installation
To install the filter/regulator assembly, follow these steps:
The glue supply lines must run from the
shutoff valve to the fluid pressure regulator.
1.
Install the small in-line glue filter (Figure 5-7) between the
shutoff valve (located at the end of the drop line) and the fluid
regulator.
It is possible to install the filter directly onto the
input of the regulator assembly. This will
eliminate the need for a hose between the
filter and regulator.
2.
Connect the applicator supply hose to the output of the fluid
pressure regulator.
3.
Close the small valve on the end of the line.
It may be necessary to fabricate parent-
machine mounting brackets for the glue
regulator assembly, the encoder assembly,
and the glue filter assembly.
Installing the
Filter/
Regulator
Assembly
3.5"
(89 mm)
4.25"
(108 mm)
6.25"
(159 mm)
3"
(76 mm)
6" (152 mm)
2-5/8" (67 mm)
diameter
Figure 5-8 - Glue Regulator with Gauge and Protector
Figure 5-7 - Glue Filter
