VALBERG 971314, Instructions For Use Manual

Page: 11 / 150

8 EN
Using the appliance
B

Connect the new water inlet hoses to a ¾" threaded tap.
• Connect the white end of the water inlet hose to the white water inlet valve located at the rear
of the machine and the red end of the hose to the red water inlet valve (if available).
• Tighten the connections by hand. If in doubt, consult a qualified plumber.
• A water pressure between 0.1 and 1 MPa is required for optimum operating efficiency (a pressure
of 0.1 MPa corresponds to a flow rate of more than 8 L of water per minute with a fully open
tap).
Ž
Once all the connections have been made, carefully turn on the water supply and check for
any leaks.

Make sure that the new water inlet hose is not pinched, twisted, bent, kinked or crushed.
• If the machine is fitted with a hot water inlet connection, the temperature of the water supplied
must not exceed 70°C.
NOTE
The appliance must be connected to the water supply
network using the new connection sets supplied with
the appliance; used connection sets must not be
reused.
~ 95 cm
~ 145 cm
~ 95 cm
~ 140 cm
~ 95 cm
~ 150 cm
0 – max. 100 cm