User's Guide ______________________________________________________________________
110 _________________________________________________________________ M210667EN-C
Setting up Transmitter Mast to Foundation
To set up the transmitter mast to the foundation, do the following:
1.
Screw one nut each on the three foundation screws until the
distance between the foundation surface and the nut top is 5 cm.
Place a washer on top of the nuts. See Figure 47 on page 94.
2.
Place the transmitter mast on the prepared foundation screws. The
interface unit at the mast base must be orientated backwards from
the baseline between the two installation places.
3.
Secure this preliminary mast position. Use a washer and a nut on
each of the three foundation screws, fix it only hand-tight.
4.
Ensure that the base plate of the mast has settled on the nuts and
washers that are mounted below.
5.
Use the level and find a perfect vertical alignment for the mast. For
that purpose loosen the respective fastening nut and align the
complete mast construction by turning the nut below the base plate.
See Figure 48 on page 94.
6.
When the mast is aligned perpendicular, secure the base plate
again, fix the nuts to ensure a stable mast position.
7.
If the level of receiver and transmitter foundation surfaces is
identically in the frame of ± 10 cm, the nuts can be finally
tightened now as tight as possible. A torque of 60 … 80 Nm is
recommended for the final fixture. See Figure 49 on page 95.
Setting up Weather Protection Hood to Support Unit
To set up the weather protection hood to the support unit, follow the
instructions below. Alternatively, the heated weather protection hood can
be mounted if ordered (part of the optional material). Both the hood types
have identical mechanical fixtures.
1.
Place the ladder in front of the transmitter mast.
2.
Then install the weather protection hood.
3.
Fix the hoods with two screws (hex-socket, size 3) at each rear end
corner of the hood. See Figure 50 on page 96.
WARNING
Death or serious injury may occur!
The AC voltage must be disconnected from the instrument. Switch the
AC off.
4.
In case a heated weather protection hood is used, lay the heater
cable inside the support unit as shown in Figure 51 on page 96.