Vaisala HUMICAP HMT310, User Manual

Page: 37 / 89

Chapter 4 ________________________________________________________________ Operation
VAISALA____________________________________________________________________ 35
Calibration and adjustment (these are presented in
Chapter 7
,
section
Calibration and Adjustment Commands
on page 64)
CRH Relative humidity calibration
CT Temperature calibration
LI Revert factory calibration
FCRH Relative humidity calibration after
sensor change
CTEXT Set calibration information text
CDATE Set calibration date
ACAL Analog output calibration
Chemical purge
PUR [ON/
OFF
] Enable or disable automatic
chemical purge
PURGE Activate chemical purge
PURR [ON/
OFF
] Enable or disable automatic
chemical purge in power up
Sensor heating
XHEAT [ON/OFF] Enable or disable sensor heating
Measurement Output
R Start Continuous Outputting
Syntax: R<cr>
Starts output of measurements to the peripheral devices (RUN-mode);
the only command that can be used is S (stop).
The output mode can be changed with command FORM.
Example:
>r<cr>
RH= 28.0 %RH T= 23.3 'C
RH= 28.0 %RH T= 23.3 'C
RH= 28.0 %RH T= 23.3 'C
RH= 28.0 %RH T= 23.3 'C
RH= 28.0 %RH T= 23.3 'C
RH= 28.0 %RH T= 23.3 'C