1 Safety
4
Installation and maintenance instructions eloSTOR exclusive 0020234040_02
port the operating weight of the product. An
uneven installation surface may cause leaks
in the product.
There is a risk of death if the connections are
subject to leaks.
▶
Make sure that the product is positioned
flush against the installation surface.
▶
Ensure that the installation surface has
sufficient load-bearing capacity to bear the
operating weight of the product.
1.3.4 Risk of scalding and material
damage due to escaping hot or cold
water
▶
If you use plastic pipes for the hot or cold
water connection of the product, you must
only use pipes that are temperature-res-
istant up to 95 °C under a pressure of 1.0
MPa (10 bar).
1.3.5 Risk of death due to lack of safety
devices
The schematic drawings included in this doc-
ument do not show all safety devices re-
quired for correct installation.
▶
Install the necessary safety devices in the
system.
▶
Observe the applicable national and inter-
national laws, standards and guidelines.
1.3.6 Risk of injury due to the heavy
weight of the product
▶
Make sure that the product is transported
by at least two people.
1.3.7 Risk of material damage caused by
using an unsuitable tool
▶
Use the correct tool to tighten or loosen
threaded connections.
1.3.8 Risk of material damage caused by
frost
▶
Do not install the product in rooms prone
to frost.
1.3.9 Risk of being burned or scalded by
hot components
▶
Only carry out work on these components
once they have cooled down.
1.4
Regulations (directives, laws,
standards)
▶
Observe the national regulations, stand-
ards, guidelines and laws.
