9 Troubleshooting
10
Installation and maintenance instructions eloSTOR exclusive 0020234040_02
Installing the flange
10. Replace the flange seal.
11. Check the inner vessel and components for scale de-
position. (
→
Page 10)
12. Screw the flange in place.
13. Screw on the earth line.
14. Insert the temperature sensor for the thermostat and
the safety cut-out into the opening provided for them.
15. Use a cube plug to place the electrical connections for
the heating elements on the terminal block.
16. Screw the cover to the product tightly.
17. Start up the product. (
→
Page 8)
8.3
Checking the inner vessel and components
for scale deposition
1.
Disconnect the product from the power supply.
(
→
Page 9)
2.
Empty the product. (
→
Page 10)
3.
Remove the flange. (
→
Page 9)
4.
If necessary, clean the inner vessel with descaling
agents or by carefully scraping it with a wooden spatula.
5.
Replace components if necessary.
6.
Install the flange. (
→
Page 10)
7.
Start up the product. (
→
Page 8)
8.4
Completing maintenance work
1.
Fit the casing.
2.
Ensure that all of the product's components have been
installed correctly.
3.
Connect the product to the power supply.
4.
Switch on the product.
9
Troubleshooting
9.1
Replacing a defective Smart Control
module
1.
Disconnect the product from the power supply.
(
→
Page 9)
2.
Undo the screws on the cover for the flange and elec-
tronics box.
3.
Pull out all plugs from the Smart Control module.
4.
Undo the two screws for the Smart Control module.
5.
Secure the new Smart Control module.
6.
Plug all of the plugs into the contacts.
7.
Screw the cover to the product tightly.
8.
Start up the product. (
→
Page 8)
9.2
Replacing a defective heating element
1.
Disconnect the product from the power supply.
(
→
Page 9)
2.
Empty the product. (
→
Page 10)
3.
Remove the flange. (
→
Page 9)
4.
Unscrew the defective heating element from the flange.
5.
Screw the new heating element onto the flange.
6.
Install the flange. (
→
Page 10)
7.
Start up the product. (
→
Page 8)
9.3
Resetting the safety cut-out
1
1.
Disconnect the product from the power supply.
(
→
Page 9)
2.
Eliminate whatever triggered the safety cut-out using
the table in the appendix (
→
Page 12).
3.
In the opening
(1)
, press the reset button for the safety
cut-out, e.g. using a screwdriver.
4.
Start up the product. (
→
Page 8)
9.4
Rectifying faults
▶
Use the table in the appendix to rectify the faults
(
→
Page 12).
10 Decommissioning
1.
Disconnect the product from the power supply.
(
→
Page 9)
Emptying the product
2.
Close the cold water stop cock.
3.
Open a hot water valve connected to the product.
4.
Drain the domestic hot water cylinder using the drain
cock.
Removing the product
5.
Remove the cold and hot water piping.
6.
Undo the screws.
7.
Lift the product and remove it from the wall.
8.
Remove the screws from the wall.
11 Recycling and disposal
Disposing of the packaging
▶
Dispose of the packaging correctly.
