Notes on the documentation
4
Installation and maintenance instructions ecoTEC pro 0020129672_03
1
1
Notes on the documentation
The following instructions are intended to guide you
throughout the entire documentation. Further documents
apply in combination with these installation and mainte-
nance instructions.
We accept no liability for any damage caused by non-
observance of these instructions.
Other applicable documents
>
When installing the ecoTEC pro, follow all installation
instructions for the various parts and components of the
system without exception.
These installation instructions are enclosed with the various
system components as well as additional components.
>
Also observe all the operating instructions included with
the system components.
1.1
Storing documents
>
Pass these installation instructions and all other applica-
ble documents and, if necessary, any required aids to the
system operator.
The system operator should retain these instructions and
tools so that they are available when required.
1.2
Symbols used
The symbols used in the text are explained below:
i
Symbol that denotes useful tips and
information
>
Symbol for a required action
1.3
Applicability of the instructions
These installation instructions are only valid for boilers with
the following article numbers:
Boiler
Type designation
Article
number
Gas
Council
Number
ecoTEC pro 24 (VUW GB 246/5-3) 0010011689
47-044-44
ecoTEC pro 28 (VUW GB 286/5-3) 0010011690
47-044-45
ecoTEC pro
28 (VUW GB 286/5-3)
(LPG)
0010011718
47-044-47
1.1 Appliance types, article numbers and Gas Council Number
The article number of the boiler can be found on the identi-
fication plate.
1.4
Identification plate
The identification plate of the Vaillant ecoTEC pro is
attached to the underside of the boiler in the factory.
The article number of the gas fired wall hung boiler can be
found in the serial number. The seventh to sixteenth num-
bers constitute the article number.
The serial number can also be found on the lift out badge
located at the bottom of the front casing of the boiler.
The serial number can also be shown on the display of the
boiler (
¬ Operating instructions
).
1.5
CE label
The CE label shows that the boilers comply
with the basic requirements of the applicable
directives as stated on the identification
plate.
– Directive 2009/142/EEC of the Commission with amend-
ments "Directive for Harmonisation of Legal Regulations
of the Member States for Gas Cosumption Appliances"
(Gas equipment directive)
– Directive 92/42/EEC of the Commission with amend-
ments "Directive Concerning the Efficiency of New Hot
Water Heating Boilers Fired by Liquid or Gaseous Fuels"
(Efficiency directive)
– Directive 2006/95/EC of the Council with amendments
"Directive Concerning Electrical Equipment for Use
Within Specific Voltage Limits" (Low voltage directive)
– Directive 2004/108/EC of the Council with amendments
"Directive Concerning Electromagnetic Compatibility"
The boilers comply with the type sample described in the
EC Type testing certificate.
PIN No. CE-0085CM0320
The boilers comply with the following standards:
– EN 483
– EN 625
– EN 677
– EN 55014
– EN 60335-1
– EN 60335-2-102
– EN 61000-3-2
– EN 61000-3-3
