Installation
Installation and maintenance instructions ecoTEC pro 0020129672_03
17
4
4.6
Wall-mounting the boiler
a
Danger!
Risk of death if the load-bearing capacity
of the fixing elements used is insuffi-
cient!
If the fixing elements or wall do not have
sufficient load-bearing capacity, the boiler
can come loose and fall down. This may
also cause leaks in the gas line, which is
potentially fatal.
>
When fitting the boiler, ensure that the
fixing elements and the wall have a suffi-
cient load-bearing capacity.
>
Check the quality of the wall.
1
3
2
4.4 Wall-mounting the boiler
>
Mount the hanging bracket (
1
) on the wall using the wall
plugs and screws (
2
) provided with the unit.
>
Hang the boiler (
3
) on the hanging bracket from above
using the hanging bracket.
4.7
Removing/fitting the front casing
2
1
4.5 Removing the front casing
Removing the front casing
>
Loosen the screw (
1
) on the bottom of the boiler using a
screwdriver or small spanner.
>
Push in both retaining clips (
2
) on the bottom of the
boiler so that the front casing is released.
>
Pull the front casing forwards using the bottom edge.
>
Lift the front casing upwards from the bracket.
Fitting the front casing
>
Place the front casing on the upper brackets.
>
Push the front casing onto the boiler so that until both
retaining clips (
2
) snap into place at the front casing.
>
Fasten the front casing by screwing in the bolt (
1
) on the
underside of the boiler.
