Vaillant ECOTEC PLUS VU 80, Installation And Maintenance Instructions Manual

Page: 3 / 76

Notes on the documentation
ecoTEC plus installation and maintenance instructions 0020134823_01
3
1
1 Notes on the documentation
The following information is intended to help you through-
out the entire documentation. Other documents apply in
addition to these Installation instructions. We accept no lia-
bility for any damage caused by failure to observe these
instructions.
Other applicable documents
>
During installation, you must observe all the installation
instructions for the assemblies and components of the
system.
These installation instructions are enclosed with the various
system parts and supplementary components.
>
Furthermore, observe all operating instructions enclosed
with components of the system.
1.1 Storing documents
>
Pass these installation instructions and all other applica-
ble documents and, if necessary, any required tools to
the system operator.
The system operator should retain these instructions and
tools so that they are available when required.
1.2 Applicability of the instructions
These instructions apply for the following products only:
Unit Type designation
Article
number
Gas
Council
Number
ecoTEC plus 806 (VU GB 806/5-5) 0010010767 41-044-68
ecoTEC plus 1006 (VU GB 1006/5-5) 0010010780 41-044-69
ecoTEC plus 1206 (VU GB 1206/5-5) 0010010791 41-044-70
1.1 Type overview
>
The article number of the unit can be found on the iden-
tification plate.
1.3 Identification plate
The identification plate of the Vaillant ecoTEC plus is
attached to the bottom of the boiler at the factory.
The article number of the gas-fired wall-hung boiler can be
found in the serial number. The seventh to sixteenth num-
bers constitute the article number.
The serial number is also located on a plate, which is placed
in a plastic fish plate behind the front flap on the underside
of the boiler. The serial number can also be shown in the
display of the boiler (
¬ Operating instructions ).
1.4 CE label
CE labelling shows that, based on the type
overview, the units comply with the basic
requirements of the following directives:
– Directive 2009/142/EC of the Council with amendments
"Directive for Harmonisation of Legal Regulations of the
Member States for Gas Consumption Appliances"
(Gas Appliances Directive)
– Directive 92/42/EC of the Council with amendments
"Directive Concerning the Efficiency of New Hot Water
Heating Boilers Fired by Liquid or Gaseous Fuels"
( Efficiency directive)
– Directive 2006/95/EC of the Council with amendments
"Directive Concerning Electrical Equipment for Use
Within Specific Voltage Limits" (Low voltage directive)
– Directive 2004/108/EC of the Council with amendments
"Directive Concerning Electromagnetic Compatibility"
The boilers comply with the type sample described in the
EC Type testing certificate
PIN no. CE-0085CM0415
The units comply with the following standards:
– EN 12828
– EN 15417
– EN 15420
– EN 50165
– EN 55014
– EN 60335-1
– EN 6100-3-2
– EN 6100-3-3
– prEN 15502-1
– prEN 15502-2