5 Assembly and installation
10
Installation instructions aroTHERM 0020147164_07
5
Assembly and installation
5.1
Preparing for fitting and installation
5.1.1
Delivery, transport and positioning
5.1.1.1 Transporting the product
Warning.
Risk of injury from lifting a heavy weight.
Lifting weights that are too heavy may cause
injury to the spine, for example.
▶
When transporting the product, two
people should lift it.
▶
Observe the product weight stated in the
technical data.
▶
When transporting heavy loads, observe
the applicable directives and regulations.
Caution.
Risk of material damage due to incorrect
transportation.
Regardless of the mode of transport, the heat
pump must never be tilted by more than 45°.
Otherwise, this may lead to malfunctions in
the coolant circuit during subsequent opera-
tion. In the worst case scenario, this may lead
to a fault in the whole system.
▶
During transport, do not tilt the heat pump
by any more than the maximum angle of
45°.
1.
Use the transportation belt to carry the product to the
final installation site.
2.
Only lift the product from the back and side where the
hydraulic connections are located.
3.
When transporting the product using a hand truck, se-
cure the product using a belt.
4.
In order to avoid scratches and damage, protect the
sides of the product that come into contact with the
hand truck.
5.1.1.2 Unpacking the product
13mm
1
2
3
4
B
A
D
E
C
1.
Remove the accessory
(2)
.
2.
Remove the documentation supplied
(1)
.
3.
Remove the transport belt
(4)
.
4.
Carefully remove the packaging and padding without
damaging the product
(3)
.
5.
Remove the screws from the pallet at the front and rear
of the product.
