![background image](http://html1.mh-extra.com/html/vaf-instruments/247/247_technical-manual_3147088015.webp)
14
6. REPAIR AND REPLACEMENT
6.1
TICKET TRAY REMOVAL
(FIGURE 14)
Turn crank to print position (print hammer down) and remove printing arm spring.
Turn crank to stop position (seal lever up).
Flip printing arm to rear and remove three groove pins from printing arm shaft.
Pull out printing shaft from left side.
Remove pin from printing arm cam.
Remove E-ring from center crank shaft. Pull shaft out from right side until flush with frame. Leave
gears engaged.
Remove all tray rod clips and tray support rods.
Lift tray up while tilting left side up.
Fig. 14: Ticket Tray Parts
Identification
6.2 WHEEL REMOVAL
Remove the ticket tray, see paragraph 6.1.
Remove the retaining ring and washer from wheel shaft (left side).
Remove the wheel aligning spring from wheel shaft (right side).
Pull wheel shaft out from right side.
NOTE:
The shaft must be pulled out slowly so wheels, bushing and washers may be removed individually
without damage to the printing wheels.
Summary of Contents for 247
Page 9: ...8 Fig 4 Lubrication points Fig 5 Lubrication points...
Page 18: ...17...