12
13
Installation
Finish the wall by tiling up to the
mortar guard, keep the final finished
wall surface between the min and max
marks.
Unscrew the 2 mortar guard screws
and remove from the wall.
Pull out the spigot from the outlet on
the left side of valve.
Cold inlet
Hot inlet
Outlet 1
Outlet 2
Connect cold supply to the lower left
inlet of the valve and hot supply to the
upper left inlet.
Connect outlet 1 to the desired channel
e.g. to the shower head.
Note:
outlet 2 will be connected to the
bath.
Mortar
guard
Mortar guard
screws
Spigot
Screw spigot into the outlet on the back
of the plate. Tighten using a 8mm hex
key.
Spigot
8mm
hex key
Plate
Installation - Trim
Guide the handset holder with spigot attached partially onto the valve and then
slide the cover plate over the threaded cartridge covers. Push on the cover plate
and handset holder. Apply a thin bead of silicone around the outside to seal against
the tiled surface.
Handle
shroud
Carefully slide the temperature handle onto the centre spline of the valve. While holding
the handle in the vertical/horizontal position screw the shroud until touches the cover
plate. The handle is etched to show alignment to the 38°c position on the plate.
Handset
holder and
outlet
Cover plate
Spigot
Threaded cartridge
covers
