453. Fertiliser tramlining LH and
RH
See alarm no. 451
461. BioDrill tramlining LH
Check the sensor’s cable, contacts and connections.
Check the sensor.
462. BioDrill tramlining RH
Check the sensor’s cable, contacts and connections.
Check the sensor.
463. BioDrill tramlining LH and RH
Check the sensor’s cable, contacts and connections.
Check the sensor.
470. CAN BUS error
Check the CAN’s wiring, connectors and connections.
520. Interrupted connection with
Gateway
No contact between iPad and
Gateway
Check that the cable is not trapped or otherwise damaged. Check the condition
of the connectors.
Check the cabling between Gateway and the terminal
760. Low speed, seed
The hydraulic motor is sitting at the lower limit for permitted speed
Check the oil flow rate
Check the calibration
Check the roller
770. Low speed, fertiliser
The hydraulic motor is sitting at the lower limit for permitted speed
Check the oil flow rate
Check the calibration
Check the roller
780. Low speed, BioDrill
The hydraulic motor is sitting at the lower limit for permitted speed
Check the oil flow rate
Check the calibration
Check the roller
790. Technical error, radar
Speed = 0
Check the sensor’s cable, contacts and connections.
Speed > 7.0 km/h less than 0.7
seconds
Check the sensor.
1080 Lost contact with Universal
Control
System has lost contact with external application
Make sure that the external application is in contact with Universal Control.
1090 AutoPilot, maximum drilling
depth
AutoPilot has reached the maximum permitted drilling depth. Check the
position of the sensor.
903099-en-gb; 19.01.2021
35
