CLIO Service Manual
CLIO Tear-down & Rebuild
5.16.2. ROM
PWB
U
NIT
–
R
EFIT
WARNING: THIS PROCEDURE ASSUMES THAT DATA STORED ON THE CLIO UNIT
HAS BEEN SYNCHRONIZED OR HAS ALREADY BEEN CORRUPTED BEYOND
RECOVERABILITY. FOLLOWING THIS PROCEDURE WITHOUT SYNCHRONIZING
USABLE DATA WILL RESULT IN THE LOSS OF THAT DATA.
1.
Lower the ROM PWB Unit (67) into position and press into place using caution not to
damage the plugs.
2.
Follow the RAM/ROM Cover refit procedure, above.
5.17. M
ODEM
PWB
U
NIT
-
R
EMOVE
&
R
EFIT
Please refer to photos 12, 17, 21 in Chapter 2.
5.17.1. M
ODEM
PWB
U
NIT
–
R
EMOVAL
1.
Follow the Keyboard Base Bottom removal procedure, above.
2.
The Modem PWB unit (55) is on the left side of the Main PWB Unit (50). Using
fingernails, grasp the Modem PWB Unit (55) and lift it straight up. Store in a secure
location.
5.17.2. M
ODEM
PWB
U
NIT
–
R
EFIT
1.
Lower the Modem PWB Unit (55) into position on the left side of the Main PWB Unit (50)
and snap it into position, using caution to avoid damaging the plugs.
2.
Follow the Keyboard Base Bottom refit procedure, above.
5.18. I
NVERTER
PWB
U
NIT
–
R
EMOVE
&
R
EFIT
Please refer to photos 23-26 in Chapter 2.
5.18.1. I
NVERTER
PWB
U
NIT
–
R
EMOVAL
1.
Follow the Display Top removal procedure, above.
2.
Locate the two #1 Phillips head screws (10)(one each at the top and bottom of the
Backlight Board).
3.
Remove the two #1 Phillips head screws (10) using a #1 Phillips head screwdriver. Store
in a secure location.
4.
Gently rotate the Inverter PWB Unit (11) clockwise 90 degrees (to vertical) and unplug
the orange Display Connection FPC (flex circuit) cable.
5.
Un-solder the backlight wires from the Inverter PWB Unit (11)(note the order in which the
wires were soldered prior to removing them) and store the Inverter PWB Unit (11) in a
secure location.
5-12
The information contained in this document is confidential and the sole property of Vadem Inc. Written
permission must be obtained to reprint or use any of this information.
AUTHORED BY ANTHONY HERNANDEZ - (415)786-2081 - [email protected]