vacuubrand MD 4C NT + 2 AK, Instructions For Use Manual

Page: 54 / 70

page 59 of 75
Position new diaphragm (F) between dia-
phragm clamping disc with square head
screw (G) and diaphragm support disc (E).
Note: Position diaphragm with pale side
towards diaphragm clamping disc (facing
pump chamber).
Make sure that the square head screw of the diaphragm clamping disc
is correctly seated in the guide hole of the diaphragm support disc.
with diaphragm clamping disc and diaphragm support disc in the dia-
phragm key.
Avoid damage of the diaphragm: Do not excessively bend or crease
the diaphragm.
Check for washers (D) between the diaphragm support disc (E) and
the connecting rod (B). Do not mix the washers from the different pump
heads, since these are set at the factory to ensure proper pump per-
formance. Make sure that the original number is reassembled at the
individual pump head.
many washers: Diaphragm clamping disc will hit head cover, causing
noisy operation and possibly causing the pump to seize up.
disc, immerse assembly in naphtha or petroleum ether. Do not inhale
vapors!
Check diaphragm (F) for damage and re-
place if necessary.
Never use a pointed or sharp-edged tool to
lift the diaphragm.
Use the diaphragm key to grip the diaphragm
support disc (E) below the diaphragm.
Unscrew diaphragm support disc (E) with diaphragm (F) and dia-
phragm clamping disc (G).
E
F