vacuubrand MD 4C NT + 2 AK, Instructions For Use Manual

Page: 40 / 70

page 45 of 75
- Use inert gas for gas ballast to avoid the formation of
to connect an inert gas supply line (see ”Accessories”,
pg. 48). This adapter replaces the standard gas bal-
last cap and allows for an inert gas line to be connect-
pressure of 17.5 psi (1.2 bar) absolute.
- Close the gas ballast valve by turning the cap 180°.
In case of low boiling solvents (when the formation of
condensate is unlikely), the use of gas ballast might be
unnecessary. Operating the pump without gas ballast in-
creases the solvent recovery rate at the exhaust waste
vapor condenser.
Important notes concerning the operation of
the exhaust waste vapor condenser
Connect the exhaust to a suitable treatment system to
prevent the discharge of dangerous gases and vapors
to the surrounding atmosphere.
Never block the gas outlet ((2) hose nozzle for tubing
I.D. 3/8” (10 mm)). The exhaust hose must always be
unobstructed and without back-pressure to enable an
unhindered discharge of gases.
Check the overpressure safety relief device (11) at the
exhaust waste vapor condenser (10) regularly; replace
if necessary. Check especially for deterioration, co-
alescence and cracks.
coolant outlet hose is always free
and that it cannot get blocked.
waste vapor condenser: 87 psi (6 bar) absolute
-
sures of additional components in the coolant circuit
(e.g., coolant valve).