E
N
G
L
IS
H
10
ADLER SERIES TRANSMITTERS STORAGE
PROCEDURE
To record remote controls for a new control unit that drives a
shutter or a sunshade proceed as follows:
CAUTION:
the first transmitter recorded determines the direction
of the motor's movement.
1.
Press the button SW1 of the module DEV-R1: the led L1
lights up
2.
Press and hold down UP and DOWN until the motor starts to
move in a direction: the led L1 turns off
3.
Release the buttons: the motor will stop
4.
Press UP or DOWN following the direction the roll-up shutter
moved prior to stopping:
- if the roll-up shutter was rising, press UP; direction acquired:
the UP button raises the roll-up shutter, the DOWN button
lowers the roll-up shutter
- if the roll-up shutter was lowering, press DOWN; direction
acquired: the DOWN button lowers the roll-up shutter, the
UP button raises the roll-up shutter
5.
End of programming
To add other remote controls, proceed as follows:
6.
Press and hold down the UP and DOWN buttons of a remote
control that is already recorded until the motor starts to move
in a direction
7.
Release the buttons: the motor will stop
8.
Press the UP or DOWN button on the new remote control
NOTE: to clear the transmitters, follow the procedure
described in paragraph MEMORY CLEARING BY MEANS OF
BUTTON SW1
DEV-T1 SERIES TRANSMITTERS STORAGE
PROCEDURE
To record remote controls for a new control unit that drives a
shutter or a sunshade proceed as follows:
CAUTION:
the first transmitter recorded determines the direction
of the motor's movement.
1.
Press the button SW1 of the module DEV-R1: the led L1
lights up
2.
Press and hold down P4 until the motor starts to
move in a direction: the led L1 turns off
3.
Release the button: the motor will stop
4.
Press UP or DOWN following the direction the roll-up shutter
moved prior to stopping:
- if the roll-up shutter was rising, press UP; direction acquired:
the UP button raises the roll-up shutter, the DOWN button
lowers the roll-up shutter
- if the roll-up shutter was lowering, press DOWN; direction
acquired: the DOWN button lowers the roll-up shutter, the
UP button raises the roll-up shutter
5.
End of programming
To add other remote controls, proceed as follows:
6.
Press and hold down the P4 button of DEV-T1 that is already
recorded until the motor starts to move in a direction
7.
Release the button: the motor will stop
8.
Press the UP or DOWN button on the new remote control
NOTE: to clear the transmitters, follow the procedure
described in paragraph MEMORY CLEARING BY MEANS OF
BUTTON SW1
UP
STOP
DOWN
P1 = UP
P2 = STOP
P3 = DOWN
P4 = PROG