ENGLISH
- 48 -
PARAMETER
VALUE
DESCRIPTION
DEFAULT
MEMO
CoS1
Safety ribbon 1 input
This menu allows enabling the input for type 1 safety ribbon, that is to say,
fixed ribbons
no
no
Input disabled (ignored by the control unit)
AP
Input enabled during the opening and disabled during the closure
APCh
Input enabled in opening and closure
CoS2
Safety ribbon 2 input
This menu allows enabling the input for type 2 safety ribbon, that is to say
mobile ribbons
no
no
Input disabled (ignored by the control unit)
APCh
Input enabled in opening and closure
Ch
Input enabled during closure and disabled during opening
Co.tE
Test of the safety edges
This menu allows setting the method of control of the safety edges
working
no
no
Test disabled
rESi
Test enabled for conductive rubber safety edges
Foto
Test enabled for optical safety edges
S.EnC
Encoder sensitivity
0
0 - 7
This menu allows the sensitivity of the rate sensor to be adjusted.
A decreased rate below the set threshold indicates the presence of an
obstacle.
If set to
0
the obstacle is only detected when the gate is stopped.
When the sensor intervenes, the gate stops and is operated in the reverse
direction for 3 seconds to remove the obstacle.
The next start command restarts the movement in the previous direction
i.Adi
Enabling the ADI device
This menu makes it possible to enable operation of the device connected
to the ADI connector.
PLEASE NOTE:
selecting
Si
and pressing MENU accesses the
configuration menu for the device connected to the ADI connector.
This menu is managed by the device itself and is different for each device.
Please refer to the manual for the device.
If the
Si
option is selected, but no device is connected, the display will
show a series of dotted lines.
Exiting the ADI device configuration menu returns to the
i.Adi
option
no
no
Interface disabled, any signals will be ignored
Si
Interface enabled
FinE
End of Programming
This menu allows to finish the programming (both default and
personalized) saving the modified data into memory
no
no
Do not quit the programming
Si
End of programming
Summary of Contents for AYROS series
Page 3: ...ITALIANO 26...
