Installation instructions
Built-in variants of gas hob
Multi-sliders GAS411/421/641/951
1014422-R09
27/07/2017
1014422-R09
4
Flush installation
The cooking zone layout of the hob to be fitted may differ from the hob illustrated!
B
825
=
=
≥500
1
2
Steel angle bonded
or screw mounted
Ra
8.5
0
-1
8.5
0
-0.5
8.5
0/+1
8.5
0/+1
Detail Z
C
D
R0–5
H
H
H
384
501
Y
Y
Ri
897
Ri
571
501
Ri
Y
Y
Y
Y
501
GAS411GSBZ, GAS421GSBZ
GAS641GSBZ
GAS951GSBZ
H
Y – Y
B
A
S*
≥85
T
≥90
Drawer/
cabinet
Side panel
900
A
60
0
903±1
507±1
≥41.5
≥41.5
Z
600
577±1
507±1
≥41.5
≥41.5
A
600
600
≥40
0
≥41.
5
50
7±1
60
0
A
Z
390±1
≥41.
5
Z
* The required clearance must be observed!
Type
A Depends on producer
B
H
Corner radius Ra/Ri
C/D
GAS411GSBZ, GAS421GSBZ
≥30 mm
≥175 mm
98 mm
5/1.5 mm
373/490 mm
GAS641GSBZ
560/490 mm
GAS951GSBZ
886/490 mm
A
Worktop depth
B
Required clearance for service replacement
H
Dimension from the top of the work surface to the underside of the gas connection
Ri
Corner radii of appliance for base plate
Ra
Outer corner radii of cut-out
S
Minimum distance between the top of the work surfaces and any drawer
T
Minimum distance between the cut-out in the back and any drawer
1
Front and rear struts may be reinforced on the underside. The strut width is determined by the producer of the stone
worktop. The minimum strut width can vary according to the property of the stone.
2
For niche width 900 mm, cut-outs in side walls left/right are necessary for servicing work where the appliance base
must be removed from below.
Installation
▸
Create an accurate installation cut-out.
–
The mounting surface can be reamed out or created by installing wood/stone supports or using the steel angle set (see Ac-
cessories).
Access to the appliance from below via the entire cut-out area must be guaranteed. For servicing purposes, the appliance
base can be removed from below.
▸
Prepare the cut-out and appliance according to the specifications in the enclosed cementing-in instructions and align the appliance
in the cut-out.
▸
Fit the four adjusting braces along the circumference of the appliance to the bore holes provided and tension the appliance against
the worktop.
▸
Carefully cement the appliance in and leave the silicone sealant to dry for at least 24 hours.
