Installation instructions
Built-in variants of gas hob
Multi-sliders GAS411/421/641/951
1014422-R09
27/07/2017
1014422-R09
3
Surface-mounted installation
The cooking zone layout of the hob to be fitted may differ from the hob illustrated!
2
B
825
=
=
≥49
0
1
600
≥40
0
H
Y – Y
B
Drawer/
cabinet
Side panel
A
S*
≥81
T
≥90
≥50
≥50
490±1
60
0
A
Ra
Ra
600
560±1
490±1
≥50
≥50
A
600
Ra
900
A
60
0
886±1
≥5
0
490±1
≥5
0
373±1
H
H
H
384
501
Y
Y
Ri
897
Ri
571
501
Ri
Y
Y
Y
Y
501
GAS411GSBZ, GAS421GSBZ
GAS951GSBZ
GAS641GSBZ
* The required clearance must be observed!
Type
A Depends on producer
B
H
Corner radius Ra/Ri
GAS411GSBZ, GAS421GSBZ,
GAS641GSBZ, GAS951GSBZ
≥30 mm
≥95 mm
94 mm
0–5/1.5 mm
A
Worktop depth
B
Required clearance for service replacement
H
Dimension from the top of the work surface to the underside of the gas connection
Ri
Corner radii of appliance for base plate
Ra
Outer corner radii of cut-out
S
Minimum distance between the top of the work surfaces and any drawer
T
Minimum distance between the cut-out in the back and any drawer
1
Front and rear struts may be reinforced on the underside. The strut width is determined by the producer of the stone
worktop. The minimum strut width can vary according to the property of the stone.
2
For niche width 900 mm, cut-outs in side walls left/right are necessary for servicing work where the appliance base
must be removed from below.
Installation
Do not damage the sealing bead.
The sealing bead must lie all around the edge of worktop.
▸
Create an accurate installation cut-out.
▸
Carefully put the appliance in the installation cut-out and press against the work surface with sufficient overlap.
▸
Fit the four adjusting braces along the circumference of the appliance to the bore holes provided and tension the appliance against
the worktop.
Combination installation
Surface-mounted combination installation is described in document 1013773. The intermediate support 1014361 or 1019199 is re-
quired for this.
