5 Care and maintenance
Inserting the activated charcoal filter
▸ Fix the metal cover
B
to the activated charcoal filter with the 4 side clips.
▸ Insert activated charcoal filter
1
with metal cover at an angle, lay flat and
then pull straight down to rest on holder.
▸ Fit metal cover
A
at the back and push up at the front until the clips en-
gage.
▸ Put back the combi filter and the grease filters.
▸ Connect the appliance to the mains power supply.
▸ With the appliance switched off, depress the
button for 5 seconds to re-
set the saturation indicator.
–
The
button stops flashing.
5.4
Changing the light bulb
For safety reasons, the LEDs must be replaced by our Customer Ser-
vices.
First the appliance must be disconnected from the mains power sup-
ply.
Burns hazard! Light bulbs get hot during operation! Allow to cool
down first.
Do not touch the light bulb with bare hands. Instead, use a fine, dry,
grease-free cloth.
▸ Using a small screw driver, carefully lever
the ring out.
▸ Replace the defective light bulb with a new
bulb of the same type (max. 20 W).
▸ Clean ring and glass insert with a dry,
grease-free cloth.
▸ Fit the ring back into the openings.
▸ Connect the appliance to the mains power
supply again.
19
Summary of Contents for DFPQS9
Page 1: ...Operating instructions DFPQS Range hood...
Page 24: ...24 10 Notes...
Page 25: ...25...
Page 26: ...26...
