V-TUF RAPID-VSC, User'S Operating Manual

Page: 14 / 36

15
Practical Advice
Avoid soaking with water the surface you then wish to treat with detergent because, in doing so, you can
place a film of water over the area you wish to treat, resulting in poor cleaning results. Instead, whilst
holding the nozzle pointing towards the ground, wait until the detergent exits the nozzle. When the
detergent exits the nozzle, approach the surface you wish to treat, start from the bottom with overlapping
strips until you reach the top of the area, sprinkling the whole are with detergent. This system is known to
avoid dripping of detergent onto dry surfaces, the residue of which could remain even after rinsing.
In order to avoid the formation of deposits or crusts, at the end of operation it is advisable to pass clean
water through the pump for a few seconds.
Important Advice
To safeguard the environment, we advise that only authorised detergents are used, that the
recommendations of use and dosage are observed on the product labels, that detergent is used sparingly
and remember that use of inappropriate detergent, as well as damaging the environment can damage the
hot water cleaner as well as the objects being cleaned.
USE DETERGENTS WHICH ARE OVER 90% BIODEGRADEABLE .
Before sprinkling detergent over varnished areas with delicate colours, make sure that the surfaces to be
treated are not hot, that the detergent has not dried and that the concentration of water / detergent is
correct.
IMPORTANT: Rinse well.
Upon completion of operation, shut down the machine then squeeze the pistol lever until the residual water
pressure has been expelled.
LUBRICATION OF THE PUMP
For the models 100.12 and 150.15 we recommend:
PL100 Lube – OIL CAPACITY 0.42 kg
You should change the oil after the first 50 hours of use, and after each subsequent 500 hours of operation.