V-TUF RAPID-VSC, User'S Operating Manual

Page: 12 / 36

13
COLD WATER USE
1.
Check that the warning light ( c ) is lit, indicating that there is electric current within the machine.
2.
Open the water source tap (2), then start the motor and pump by pressing the appropriate switch (in)
on the control board. This will light the relevant light (a).
3.
Squeeze the pistol lever (3) to obtain water flow to the lance (4).
HOT WATER USE
Check that the diesel tank is full (1); if it is not, refill it using exclusively automotive diesel.
Repeat points 1 and 2 as per cold water use.
Check that the thermostat (tr) is positioned at 0°C, start the boiler by means of the appropriate switch (br)
which will cause the relevant light to illuminate (b), wait for 30 seconds so that the diesel pump can refill,
turn the knob of the thermostat (tr) to the required temperature (upon reaching the desired temperature,
the burner will cut off automatically to then restart upon any lowering of temperature. Squeeze the pistol
lever (3) to obtain water flow to the lance, adjust the lance nozzle accordingly to control the outflow (4) and
then start your job.
To close down the machine, turn the thermostat (tr) to zero, keep the pistol open (3) and allow the water to
cool, turn off the boiler (br) turn off the water supply (2), turn off the motor and pump (in), then squeeze
the pistol lever (3) until the residual water pressure has been expelled.
ATTENTION
In case of lack of diesel the burner will stop burning, either turn the burner off immediately or fill the fuel
tank back up with diesel.
ATTENTION
This Machine is NOT equipped with a safety device to protect it from insufficient water supply. It is the
user’s responsibility to ensure that the water supply is consistent.
ATTENTION
The machine is equipped with TS system which will stop the machine immediately after water pistol is
released. The machine will start up again once the pistol is pulled again.