V-Trak Lite Hardware installation
Backrest Angle (pitch):
Slacken the two Centre Clamp Fixing Screws –
7
.
Angle the backrest forwards or backwards to the
desired position –
8
and re-tighten both Fixing
Screws.
Seat Depth: - 11
1. Raise both Locking Levers to the open position
2. Slacken both Arm Locking Screws
3. Slacken the Mounting Block screws sufficiently
to allow the Mounting Blocks to rotate –
9
4. Rotate the Mounting Blocks until the desired
position is reached –
10
.
5. Tighten the Arm Locking Screws and close the
Locking Levers
6. Tighten the Mounting Block Screws
7. Check for easy removal/replacement of the
backrest and adjust if necessary.
Backrest Rotation & Offset:
1. Proceed as for seat depth adjustment but
rotate Mounting Blocks differently to achieve the
angle required –
12
.
2. To change or reinstate the central position,
slacken the Centre Clamp and slide sideways to
the required position –
13
21. Secure in position by tightening all fixing
screws and closing the Locking Levers.
Note: The Central Clamp is designed to grip firmly
to resist movement and may do so even when
fixing screws have been slackened. Further
movement of the hardware may be needed to
disengage the clamp before adjustments can be
made.
7
8
9
10
11
13
12
Summary of Contents for Backrest
Page 1: ......
Page 30: ...Choosing a backrest system...
