V-Trak Lite Hardware installation
Once mounting blocks have been positioned with
hardware. Check that the V-Trak Lite hardware can be
removed and replaced easily when both Locking Levers
are opened. If it cannot, the Mounting Blocks may not be
level or the Locking Pins may not be correctly aligned.
Continue adjustments until removal and replacement is
smooth and easy -
1
.
Universal Mounting Blocks include a selection of Spacers
and Clamp Bands to suit different cane diameters.
Observe the correct position for any Spacers which must
not be in contact with the tightening Wedges -
2.
If in doubt please refer to fitting instructions that come
with the Mounting Blocks.
Installing the Backrest:
1. Remove the mounting system from the mounting
blocks.
2. Remove the protective End Cap from one end of the
Mounting Track –
3
.
3. Slacken the Centre Clamp Fixing Screws to allow the
Track Slider to mount onto the backrest track
4. Insert the Track Slider into the track and move the
assembly to the desired position –
4
. Ensure its
orientation before clamping (Locking Pins should be
facing down).
5. Secure in place with the Centre Clamp Fixing Screws -
5
.
6. Install the completed backrest in the wheelchair and
secure by closing the Locking Levers.
7. Replace the protective End Cap.
Adjustments: Backrest Height:
For
fine
adjustment of the backrest height, slacken the
two Centre Clamp Fixing Screws –
5.
Move the backrest
up or down to the desired position –
6
, and re-tighten
the Fixing Screws.
If this adjustment significantly alters
the pivot position, it may be necessary to adjust the
height by repositioning the mounting blocks on the
wheelchair canes.
1
2
3
4
5
6
Summary of Contents for Backrest
Page 1: ......
Page 30: ...Choosing a backrest system...