The DMX512 Channel
通道说明
Channel
通道
Function
/
功能
Introduction
说明
1CH
Dimmer
/
调光
0-255 LED Dimmer Linear dimming from dark to bright 0-255
LED
调光 线性调光 由暗到量
2CH
Strobe
/
频闪
0-255 Stroboscopic speed adjustment
0-255
调节频闪速度
address code state, multimachine connection, without control table, which can realize the master-slave
online features, operation of a device, the rest in address d001 state of the host device synchronized wit
h the running program. Through to control if receives the control table, behind the podium display X bec
ome V, the address in the state of equipment can be controlled to control
在地址码状态，多机连接后，若没有接控台，可实现主从联机功能，操作其中的一台设备，
其余的在地址 d001 状态下的设备跟随主机同步运行程序。接通控台后若接收到控台信号，
显示屏的的 X 会变成 V，在地址状态下的设备可受控台控制。
DMX connection DMX
连接
DMX512 is widely used in lamp control, and can control up to 512 channels
On the last luminaire, a terminator is required for the DMX signal line. Solder a 120
Ω
,
1/4W resistor between pin2 and pin3, install it into the 3-pin XLR plug and plug it into the
DMX output port of the last lamp.
Use the XLR signal cable to connect the lamp, one end to the output port of the lamp, and
the other end to the output port of the next lamp. The XLR signal cable can only be used in
series, not parallel. DMX512 signal transmission speed is very fast. Damage to the signal
line, weak welding, poor contact, etc., will affect signal transmission and cause the system
to shut down.
When the power supply of a certain lamp is cut off, the connection of DMX output and
input is bypassed, so that the connection of DMX line can be maintained.
Each lamp needs an address code, which can receive the information sent by the console,
ranging from 0 to 512. The terminal of the system needs to be equipped with a terminator
to reduce signal transmission errors.
DMX address code setting
When using a universal DMX console to control a lamp, please set the start address code
save
5
Now temp
灯珠温度
/
Lamp bead temperature
实测灯珠的当前温度
/Measure
the current temperature of the
lamp beads
