Version 16.01.2018
HW:25-GD (V101)
CI-VL3-R40
P
a
g
e
19
2.8.
Picture settings and guide lines
The picture settings are adjusted by the 3 buttons on the video-interface. Press the
MENU
button to open the OSD settings menu. To switch to the next menu item. pressing
UP
and
DOWN
will change the selected value. The buttons are embedded in the housing to avoid
accidental changes during or after installation. The picture settings have to be done
separately for RGB, AV1 and AV2 while the corresponding input is selected and visible on the
monitor.
Note:
The OSD menu is only shown when a working video source is connected to the
selected video-input of the interface.
The following settings are available:
Contrast
Brightness
Saturation
Position H (horizontal)
Position V (vertical)
IR-AV1 (out of function)
IR-AV2 (out of function)
Guide-lines left
Guide-lines right
Guide lines (ON/OFF)
Note:
If the CAN-box does not support the vehicle’s CAN, the guide-lines cannot be used.
Optionen: GUIDE-CNTRL
All ON
: Guide lines und PDC werden
angezeigt
PDC ON
: Nur PDC wird angezeigt.
Guide ON
: Nur Guide lines angezeigt.
ALL Off
: Guide lines und PDC
werden nicht angezeigt.
