b.
By
Sampling method
when the unit piece weight is not
known
5.5.a Procedures of Direct Entry Method
3
a.
Refer to
5.1
and
5.2
for zero and tare
b.
Enter the unit piece weight and confirm by pressing
@WT/SET.
The unit piece weight is now displayed on
the
UNIT WEIGHT PANEL
NOTE:
Under this method, the
AUTO PIECE WEIGHT
ENHANCEMENT
FUNCTION
will be disabled for same
subsequent counting.
5.5.b Procedures of Sampling Method
a.
Refer to
5.1
and
5.2
for zero and tare
b.
Place a sample with known quantity on platter
c.
Enter the quantity of the sample through the numeric
keypad and confirm by pressing
NUMBER SET
d.
The scale will automatically determine the unit
piece weight. The unit piece weight will then be
displayed on the
UNIT WEIGHT PANEL
e.
Sampling process is now completed
3
When the individual unit piece weight is not standardized, it is
strongly r ecommended that unit piece weight should be obtained through
Sample method as described in
5.5.b.
5.6 AUTO PIECE WEIGHT ENHANCEMENT FUNCTION
In order to obtain the best counting result and to avoid
and minimize sampling error, this scale is equipped with
AUTO UNIT PIECE WEIGHT ENHANCEMENT FUNCTION
.
This function will automatically be employed when the
unit piece weight is obtained through the sampling method
as described in
5.5.b
.
5.6.1 How AUTO UNIT PIECE WEIGHT ENHANCEMENT FUNCTION
Works
After a unit piece weight is obtained by methods as
described in
5.5.b
, then place more loads onto the platter.
The n ew quantity will be shown on the
TOTAL COUNT PANEL
.
The
AUTO UNIT PIECE WEIGHT ENHANCEMENT FUNCTION
will
update the unit piece weight if both requirements of
below are met:
a.
The quantity added to platter is more than 4 pieces,
and
b.
The quantity added to pla tter is less than 100% of
previous maximum counts previously attained from
the same transaction.
If the above requirements are met, a new unit piece weight
will be displayed on the
UNIT WEIGHT PANEL
and confirmed
by an audio "beep".
