Hallett 15xs Instruction Manual
Released on 11-Jul-13 – H800003Q
Page 40
UV Pure Technologies Inc. © 2013
Step 4:
Reconnect the flexible hoses (8), both top and bottom. Close the front
panel.
Step 5:
Close any faucets and open the water supply. Inspect for leaks. The
solenoid valve (optional) can be placed into manual mode to allow water to enter
the unit. Switch back to automatic mode when done. Repair any leaks if
necessary.
Caution:
Do not operate the unit if there are any leaks at the piping
connections or within the unit.
Step 6:
Replace the lamps.
Step 7:
Reinstall the top and bottom covers.
Step 8:
Plug in the unit.
Step 9:
Make an entry in the service record to establish a cleaning schedule.
HOLE ON END
OF WIPER SHAFT
MUST BE ON TOP
ALIGN HOLE IN
SHAFT ADAPTER
WITH THE
WIPER SHAFT
Replacement Parts
Use only genuine UV Pure Technologies’ parts when servicing your Hallett
disinfection system. Failure to use genuine UV Pure Technologies’ replacement
parts will void the factory warranty, and any laboratory validation and/or
certification for water safety and system operating performance. Figure 4B shows
a complete list of original factory parts.
Replacement parts and service are available from your Installer, a Certified
Service Dealer (CSD), or directly from UV Pure Technologies on our
e-commerce site:
www.uvpuredirect.com
. A complete list of Certified Service
Dealers and their coverage areas is available on UV Pure’s website:
www.uvpure.com
.
Manufactured by:
UV Pure Technologies Inc.
60 Venture Drive, Unit 6
Toronto, Ontario, Canada, M1B 3S4
416-208-9884, 1-888-407-9997
FAX 416-208-5808
e-mail inquires:
www.uvpure.com
Date of Purchase:
Figure 4E
