background image

888.277.2596  •  [email protected]  •  UVANGEL.COM

Copyright UV Partners, Inc. All rights reserved. UV 

Angel® and UV Angel Air® are registered trademarks 

of UV Partners, Inc.

Page 10 of 10

902-0003-04

Cleaning

Regular cleaning of the UV Angel Clean Air will be needed in addition to replacing the UV lamp and air 

fi lter annually. The frequency of cleaning the fi xtures depends on the amount of debris and dust in the 

environment, but even cleaning once a year will help. Follow these guidelines for cleaning UV Angel Clean Air 

fi xtures leaving them looking and working great.

1. 

Do not clean a light fi xture with the power on to avoid electrical hazards.  The switch and the breaker 

should be turned off and the fi xture should be completely cooled prior to cleaning.

2. 

Stand on a stable surface to protect yourself from accidents. Use a sturdy ladder instead of a chair. 

Consider enlisting the help of a friend to have a second set of hands.

3. 

The basic tool you will need is microfi ber towels. Never use a terry cloth towel since it can scratch the 

surfaces of the fi xture. Microfi ber is also ideal for picking up dust, so you might not even need to clean 

with anything more depending on the state of your fi xture.

4. 

If there is excess dust build up in the vent louvers vacuum them with a soft brush nozzle prior to wiping 

down.

5. 

If the fi xture hasn’t been cleaned in a long time a cleaning solution may be needed. Use warm water and 

any mild, non-abrasive household detergent like dish soap. Dampen a microfi ber towel with the solution 

to whip down surfaces.  Then rinse those same surfaces with a separate towel dampened with clean water.  

Dry with a clean towel.   

6. 

Assure the fi xture is dry prior reapplying power.

If you experience an issue with your UV Angel Clean Air product, please 

contact our team at 888-277-2596 or email us at 

[email protected]

 for 

troubleshooting assistance or help with ordering a replacement part. 

Warranty

• 

Mechanical, light panel, ballast, and drivers - 5 years

• 

Fans and other electrical components - 2 years

• 

Consumables - UV-C lamp annually / Air fi lter annually

EPA Est. No. 95756-GA-1
EPA Est. No. 89661-MEX-1

UV ANGEL  

233 Washington Ave., Suite L1, Grand Haven, MI, 49417

5

YEAR LIMITED

WARRANTY

Meets California ozone emissions limit.  CARB certifi ed.

This product can expose you to chemicals including mercury which is known to the state of California to cause birth defects or other reproductive harm. 

For more Information, go to www.P65Warnings.ca.gov

There are no known health hazards from mecury exposure from a lamp that remains intact.

Lamps should be disposed of per local regulations. For more information on clean-up and disposal, see www.lamprecycle.org. 

May be Patented, see: www.uvangel.com/patents

Summary of Contents for Clean Air











Reviews: