General Safety Advice
Page 11 of 28
3.
Remove the CryptoServer plug-in card from the computer. Follow the instructions for
removing PCIe plug-in cards as specified in the operating manual for your computer as
well as the instructions in chapter 4.3 of the current document.
4.
Put the CryptoServer plug-in card into an antistatic wrapping and in the original packaging.
If you need an original packaging or/and antistatic wrapping, please contact the
manufacturer Utimaco IS GmbH.
5.
After reaching destination, put the computer, where the CryptoServer plug-in card should
be installed in, to the required position, and then install the CryptoServer plug-in card.
Follow the instructions for installing PCIe plug-in cards as specified in the operating
manual for your computer as well as the instructions in chapter 4.2 in the current
document.
2.4
Environmental Temperature
CryptoServer Se must only be operated and stored in a particular temperature range.
■
You must make sure that the CryptoServer Se is always stored at temperatures between -
10 °C and +55 °C (+14 °F to +131 °F).
■
You must make sure that the CryptoServer Se is always operated at temperatures
b10 °C and +45 °C (+50 °F to +113 °F).
If the environmental temperature drops out of the permitted range, the device sensor will
delete all the data on it.