UTAH SCIENTIFIC UTAH-100/UDS 10x10, System Setup And Operation

Page: 108 / 131

A-2 RCP-1 Protocol for UDS
RCP1 Protocol for UDS
Matrix Change Report Enable
ASCII CODE HEX
Command Code: ESC B 1B, 42
Response: None
The Matrix Change Report Function causes the controller to issue a status update
whenever a change occurs in the Matrix Status. A change in status occurs when a Take is
made resulting in a change to the status of the matrix. If a Take is made to a destination
requesting the same sources that is already selected, then this will not cause a change in
status, and consequently this will not be reported.
The ESC B Sequence causes the System Controller to enable the Matrix Change Reporting
Function. Until the function is disabled, the controller will report changes in status without
further request.
The change report data format is as follows:
FS OOOO <Matrix Input> <Matrix Output> <Checksum> CR
Related Commands:
MATRIX CHANGE REPORT DISABLE
Matrix Change Report Disable
ASCII CODE HEX
Command Code: ESC C 1B, 43
Response: None
Matrix Change Reporting is described in detail in the previous section.
The ESC C Command sequence disables the Matrix Change Reporting Function.
Related commands:
MATRIX CHANGE REPORT ENABLE