MOWOOT II
usMIMA S.L.
User Manual
Version 10
Page. 11/20
6. STARTING THE TREATMENT SESSION
1.
Verify the main switch (back side of the console) is in OFF position.
2.
Connect the DC power adapter cable to the DC adapter socket (located under the Main
Switch).
3.
Connect the power cord to the electrical outlet.
4.
Put on the abdominal belt, following the instructions in Section 3.3 above and get into a
comfortable seated, reclining, or lying position from where you can easily reach the console
controls.
5.
Connect the belt to the desktop device and make sure that the hoses are properly
connected (3.4).
6.
Turn on the Main Switch to the ON position.
7.
Press the Start/Pause button. - Treatment begins.
7. ENDING THE TREATMENT SESSION
When your treatment time is complete, MOWOOT II system will stop. If you need to pause the
massage during the treatment session, press Start/Pause button. If you need to definitely stop the
treatment before massage is finished, press Stop button. At the end of treatment, turn OFF the
console using the Main Switch.
NOTE - When immediate abdominal belt deflation is necessary, disconnect the belt from the console to
immediately deflate the air pressure in the belt actuators.
8. MAINTENANCE & STORAGE
8.1 Cleaning
Gently wipe the external surfaces using a soft cloth, warm water and a mild detergent. Wipe with
clear water. Wipe dry using a soft towel only. When dry, the external surfaces may be wiped down
with alcohol. When using alcohol, wear gloves and work in a well-ventilated area. Allow the device
to air dry completely before use.
8.2 Console Cautions
Disconnect the console from electrical outlet before cleaning. Let it dry completely before
reconnecting it to the electrical outlet. o not allow any moisture or liquids to enter the console.
8.3 Belt Cautions
Never submerge the belt in liquid. Do not hand or machine wash. Do not use bleach. Do not wring,
iron, tumble, do not dry mechanically or dry with dry heat. Do not allow liquid to get into the air
inlets.
8.4 Storage & Transportation
Keep the device away from direct sunlight, store in a dry, shaded place, do not twist or fold the
connector tubes and store the power cord lightly wrapped and secured.
The components of the MOWOOT II system should only be transported in their original packaging.
