18
rEmovInG tHE rUBBEr rollErS
Photo 18-1
NOTE:
Only remove rollers if they are cut or in poor
condition.
NOTE:
The following procedure removes all 4 rollers.
In certain instances, it is not necessary to remove all 4 rollers,
therefore, remove as required.
STEP 1:
remove all film from laminator. Photo 18-1.
STEP 2:
Unplug laminator. make sure it is cool.
STEP 3:
remove the side housing on both sides of the laminator.
STEP 4:
remove the top heat shoe. Photo 18-2.
refer to diagram and instructions on page 1
6
.
STEP 5:
Unfasten and remove the pressure adjusting screws and
springs on both sides of the laminator. Photos 18-3, 18-4.
STEP 6:
loosen the allen head set screws on the left and right ends of the top
rubber rollers. Photo 18-5.
Photo 18-2
Photo 18-3
Photo 18-4
Photo 18-5
Summary of Contents for CSL2700
Page 29: ...29 PART 1 cSl WIrInG dIaGraM...
Page 30: ...PART 2 cSl WIrInG dIaGra 30...
Page 33: ...33 NOTES...
Page 34: ...Revised 5 1 17...