IM 50.560CA UA (B/4-03)
DEPOLOX
®
3
PLUS
RESIDUAL ANALYZER
8
2.1
DEPOLOX 3
plus
NOTE: For safe and effective installation a knowledge of the con-
nected devices is required with respect to operation, electrical con-
nections, measurement signals, cable assignment, fuses and the safety
regulations which have to be observed. The installation of the device
therefore is only to be done by qualified and authorized skilled elec-
tricians.
CAUTION: Incorrectly connected devices may be damaged or de-
stroyed when switching on or during operation, or may cause mal-
functions in other devices. Be careful not to confuse measuring cables
and other cables and not to let them come into contact with one an-
other. Do not connect or disconnect live cables.
2.1.1 Unpacking
Check the transport packing for damage. Notify the carrier immediately
if there is damage, otherwise your claim for compensation will be nulli-
fied.
If the device has suffered damage, get into touch with the responsible
USF/W&T representative immediately. Keep the packaging until the
system has been properly installed and is in operation.
2.1.2 Check Voltages
The line voltage of the DEPOLOX 3
plus
is set at the factory in accordance
with the instructions given at the time of the order (230 V or 115 V).
Check this setting from the rating plate immediately after unpacking the
device, and in any case before it is installed.
If the line voltage setting does not match your supply, the setting will have
to be altered (refer to paragraph 2.1.3, Adjust Line Voltage/Change the
Fuse).
2.1.3 Adjust Line Voltage/Change Fuse
The rating plate on the top of the device shows the line voltage which was
set at the factory. If this does not match the voltage at the site of installa-
tion, the device will have to be adjusted.
NOTE: Operating the device with the wrong voltage can lead to the
device fuse blowing or other damage or malfunction. Adjustment of
the line voltage must take place before installation and before the
!
