Installation
05/20
Fl Detect RF Set
11
Up to 30 wireless water detectors can be assigned to one
wireless group!
5.5
Deleting the programming
Press and hold the button of the wireless water detector to be deleted
for approx. 5 seconds until the red LED flashes approx. twice per
second.
After approx. 2-3 seconds, the LED flashes approx. once per second -
keep the button pressed until the LED flashes twice as fast.
Release the key again.
The wireless water detector is then in normal mode again, but without
belonging to a wireless group.
5.6
Functional test
For the test, bridge the three sensor surfaces by placing the wireless
water detector (1) connected to the Fl e.g. on a plate that is
slightly filled with water.
The detector emits a loud beep as long as you bypass the sensors.
The Fl will immediately shut down.
Reset the Fl.
For the test, bridge the three sensor surfaces by placing the wireless
water detector (2), for example, on a plate that is slightly filled with
water.
The detector (2) emits a loud signal tone as long as you bypass the
sensors. After that the detector (1) connected to the Fl will
give an alarm and the Fl will block.
If possible, test with some water on the floor to see if the
alarm works in practice.
