Installation
05/20
Fl Detect RF Set
10
5.4
Commissioning
Unscrew the upper parts of the two wireless water detectors and
insert a 9V battery in each.
Only 2 wireless water detectors that are currently to be
programmed may be put into operation at the same time
and not all of the detectors used in the house!
Press and hold the internal button for approx. 2-3 seconds on a
wireless water detector. The red LED will then start flashing
approx. once per second.
Release the key again.
The wireless water detector is now in programming mode for
approx. 60 seconds.
Immediately afterwards, press the button for approx. 2-3
seconds on another wireless water detector. The red LED will
then start flashing approx. once per second.
Release the key again.
The wireless water detector is in programming mode for approx.
60 seconds. Both radio water detectors automatically program
each other into a radio group. The programming process can
take up to approx. 60 seconds in total.
If the programming was successful, the red LEDs on both
wireless water detectors light up permanently for 2-3 seconds.
If after approx. 60 seconds the red LEDs do not light up
permanently for 2-3 seconds, the programming procedure was
not successful and the wireless water detectors return to normal
mode.
In this case the programming procedure must be repeated.
