Datasheet & Quick Reference, S2B2232I/E v1.2
www.usconverters.com
www.usconverters.com
Page 8
?
Inquire the current mode of the adapter.
1.
SEARCH=
This command is used to search for any Bluetooth device in the neighborhood within one
minute. If any device is found, its name and its 12-digit-address will be listed. The search
ends with a message “Inquiry ends. xx device(s) found.” This command is available only
when the adapter is in the master role by manual.
?
Inquire Bluetooth devices in the neighborhood, listing 8 devices the maximum
STATUS=
Inquire all the current setting of the adapter.
T
Inquire the inner temperature of the IC in centigrade
?
Display the current setting of the adapter
STOP=
This command is used to specify one or two stop bits of COM port.
The command will need 200ms delay.
(Default)
1
One stop bit.
2
Two stop bits.
?
Inquire the current setting.
VERSION=
This command is used to inquiry the firmware version.
?
Inquire the version codes.
Some commands are unavailable under certain conditions:
Federal Communications Commission (FCC) Statement
RADIO FREQUENCY INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try correcting
the interference by one or more of the following measures:
-
Reorient the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into and outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
-
Warning: A shielded-type power cord is required in order to meet FCC emission limits and also to prevent interference to the
nearby radio and television reception. It is essential that only the supplied power cord be used.
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void
your authority to operate the equipment.
The information contained in this document is subject to change without notice.
FCC ID: XJ8-BT-232B
CCAB09LP2610T2 1177
