USC SEED 16 Series, Operator'S Manual

Page: 16 / 124

Page 16
Seed Series 16 & 20 Conveyor
Installation
Installation
Section
Section
B
B
HIGH VOLTAGE ~ Always disconnect the power source before
working on or near the control panel or lead wires.
HIGH VOLTAGE ~ Use insulated tools when making adjustments
while the controls are under power.
Permanent installation may require additional electrical cords
since each installation is unique.
ASSEMBLING UNDERCARRRIAGE
1. Lay the Axle flat on the ground (A) .
2. Mount both tires (B).
3. Assemble the upper arm weldments to the axle
(C)
.
4. Assemble the upper cross member to both arms. Make sure you use the one with
two pulleys on it
(D)
.
5. Attach the upper cross braces (E) .
6. Using the upper arm pin, assemble the Transport Slide (F) .
7. Assemble the lower arm weldments to the axle
(G)
.
8. Assemble the lower cross member to both arms. Make sure you use the one with
one pulley
(H)
.
9. Attach the lower cross braces (I) .
10. Tighten all of the fasteners.
The following instructions should be used to assemble your USC conveyor
undercarriage. Hand tighten all fasteners until undercarriage is completely assembled.