USC SEED 16 Series, Operator'S Manual, Page: 25 / 124

Page 25
Seed Series 16 & 20 Conveyor
The following steps outline the initial set-up of your Seed Series Conveyor:
1. Clear the area of bystanders, especially small children, before starting.
2. Be sure there is enough clearance from overhead obstructions and power lines
or other equipment to move the machine into its working position.
3. Attach the Conveyor to an appropriate towing vehicle.
4. Move conveyor as near as possible to desired position.
5. Set the park brake on the towing vehicle before dismounting.
6. Unhook the unit from the towing vehicle.
7. Use the winch to raise the machine so it clears the truck, trailer or wagon.
8. Place chocks in the front and rear of each wheel.
9. It will be necessary to stake or weight the intake end to prevent upending when the
machine is emptying.
10. Review the Workplace Safety Diagram for your model prior to starting work. Follow
all setup instructions and do not allow any unauthorized people into the working
area.
11. Have a certified electrician provide power to the conveyor. Provide convenient
shutdown switches and comply with local electrical codes. The conveyor can also
be plugged directly into a USC seed treater control panel.
Ensure that the seed treater panel and the conveyor are rated for
the same power before plugging the conveyor into the seed treater
panel.
12. Reverse the above procedure when removing the machine from its working
position.
CONVEYOR SET-UP