Page 20
LPV SEED TREATER
LPV AUTOMATED TREATER SET
-
UP (ALL LPV TREATERS)
STEP F:
Insert a cotter pin (06
-
09
-
0087)
in the clevis pins at both ends of the actuator.
Then, attach the yellow cable to the motor connector
STEP D:
Insert a clevis pin (06
-
09
-
0058) attaching
the bottom of the actuator to the bracket on the treat-
er frame cross member.
When removing the actuator (03
-
17
-
0104) from the
box, ensure that you do not allow the shaft to rotate.
The actuator was installed and tested at the factory
so the shaft is in the correct position before it was
disassembled prior to shipping.
STEP E:
Insert the second clevis pin (06
-
09
-
0058)
and the two flat washers (06
-
05
-
0005) attaching the
end of the actuator piston to the bracket on the drum
frame. The washers should be on the outside of the
frame bracket.
If the treater drum is setting on the dead stop pins
and the shaft mounting hole on the actuator is short
of lining up to insert the clevis pin, you may rotate
the shaft one half rotation only to lengthen it.
Any more rotation could affect the proper
travel length.
NOTICE
