Adding/Replacing Optional 2-way LCD Transmitters
When adding a 2-Way LCD transmitter to the system, follow these steps:
1. Turn the ignition key On, Off, On, Off, On, Off, and back On. (Key On 4 times)
3 seconds Later the siren/horn will chirp 4 times.
2. Press and hold the Override switch for 5 seconds.
The siren/horn will chirp 4 times.
The LED will illuminate.
3. Press Button 1 on the first transmitter.
The siren/horn will chirp once.
4. Repeat steps 3 to add an additional 2-way transmitter.(2 total)
5. Turn off the ignition key.
NOTE:
All 2-Way or Standard Transmitters must be programmed at the same time.
Programming 1 new transmitter will automatically delete existing transmitters not programmed
in the same session.
Entering System Programming:
This system is compatible with the optional LCD 2-way transmitter, the standard transmitter or
as a factory upgrade (no transmitters); all system programming can be performed using either
mode.
To enter System Programming:
1.
Turn ignition ON.
2
. Within 5 seconds, press the valet switch 5 times.
The siren/horn will provide three chirps, indicating that you have entered Programming.
3.
Press the valet switch the number of times equal to the System Parameter you
want to change.
The siren/horn will chirp each time the valet switch is pressed.
4.
Within 5 seconds, press the transmitter button corresponding to the desired
operating mode for that System Parameter.
The siren will chirp to indicate the setting.
1 chirp =
Button 1
2 chirps =
Button 2
3 chirps =
Button 3
5
. When you are finished, turn off the ignition to save the changes.
Factory Upgrade Mode Programming:
Turn Ignition Off and back On once to select column 1
Turn Ignition Off and back On twice to select column 2
Turn Ignition Off and back On three times to select column 3
Page 3
Summary of Contents for AS62UG
Page 1: ...AS62UG INSTALLERS INSTRUCTIONS ...
Page 10: ...AS62UG Not Used ...