6
Visit us online at www.USWaterSystems.com Give us a call at: 1-800-608-8792
Where To Install The Water Filter
How Your Water Filter Works
The principle behind water filtering is simple chemistry. A water filter contains media which
is designed to capture contaminants as water passes through the media bed. When water
passes through the filter, chlorine, chloramines and fluoride are attracted to the media. The
result is removal of these contaminants from the water stream.
This system is controlled with simple, user-friendly electronics displayed on a LCD screen.
The main page displays the current time and the remaining days in calendar clock mode.
The system will also scroll through other pertinent information.
Place the filter as close as possible to the
pressure tank (well system) or water meter
(city water).
Place the filter as close as possible to a
floor drain, or other acceptable drain point
(laundry tub, sump, standpipe, etc.).
Connect the filter to the main water supply
pipe BEFORE the water heater.
DO NOT
RUN HOT WATER THROUGH THE FIL-
TER
. The temperature of water passing
through the filter must be less than 100
deg. F.
Do not install the filter in a place where it
could freeze.
Damage caused by freez-
ing is not covered by the warranty.
Put the filter in a place water damage is
least likely to occur if a leak develops. The
manufacturer will not repair or pay for wa-
ter damage.
A 120 volt electric outlet is needed within 6
feet of the filter. The transformer has an
attached 6 foot power cable.
Be sure the
electric outlet and transformer are in an
inside location, to protect from wet
weather.
If installing in an outside location, you must
take the steps necessary to assure the fil-
ter, installation plumbing, wiring, etc. are
protected from the elements and contami-
nation sources.
Keep the filter out of direct sunlight
.
The sun’s heat may soften and distort
plastic parts.
US Water Ultimate
Dual Tank Superfilter
